Celebrating UW Wrestling with Print-N-Stick Fabric | LexJet Blog
BEGIN TYPING YOUR SEARCH ABOVE AND PRESS RETURN TO SEARCH. PRESS ESC TO CANCEL

Celebrating UW Wrestling with Print-N-Stick Fabric

University of Wisconsin Photo Wall Mural
Photograph used for the photo wall mural, printed on LexJet Print-N-Stick Fabric by AW Artworks, by David Stluka Photography.

It’s a request that’s becoming more common: Can you put up graphics and murals that I can easily tear down and replace without damaging the wall? Andy Wredberg, owner of AW Artworks in Sun Prairie, Wis., has just the print material for that request: LexJet Print-N-Stick Fabric.

The University of Wisconsin’s wrestling program was looking for replaceable graphics featuring its current wrestling team national tournament qualifiers, and a photo wall mural for its offices.

Pillar Prints by AW Artworks“We applied the images of their national qualifiers to the big concrete pillars that run through the wrestling center. They have summer camps in the center and wanted something the kids would see and aspire to while they’re in there,” explains Wredberg. “The surface of each pillar is rough and has a lot of imperfections, but the Print-N-Stick contoured to the surface variances really well.”

Wredberg printed six poster-sized images (18” x 36”) for the wrestling center pillars. To ensure an even presentation across the wrestling center, Wredberg added Bucky Badger, UW’s mascot, to the mix since there were five national qualifiers represented.

Bucky Badger printed on LexJet Print-N-Stick Fabric“With the tight weave and bright white point and the Print-N-Stick Fabric, the blacks are blacker and it has a richness you don’t typically see in a fabric,” says Wredberg.

For the office mural, Wredberg printed three and half 44”-wide panels applied vertically from ceiling to floor. The photo mural commemorates the record-breaking attendance (more than 10,000) at the most recent Big Ten wrestling tournament held at UW’s arena. David Stluka Photography captured the image from the Big Ten tournament used for the photo wall mural print.

“To make sure everything lined up we picked a few of the elements – the signs and banners going across the picture horizontally – to key off of. The whole thing went up quickly and easily; I was pleasantly surprised. From start to finish, including taking all the furniture out, installation and trimming, it took about an hour and a half. I couldn’t be more pleased,” says Wredberg.

LexJet Print-N-Stick Fabric
Mission accomplished: The boring Jumbotron image was seamlessly replaced, actually covered up, with a swatch of Print-N-Stick emblazoned with the Wisconsin logo.

As a final touch, Wredberg is changing the image on the Jumbotron in the photo. Actually, he’s not replacing it, but printing a new image to be placed over it on Print-N-Stick Fabric. We’ll add a photo of the updated mural to this post when it’s been applied, so check back to see how it turned out.

“After we applied the mural they asked if we could put something different on the Jumbotron because the current image is kind of boring. So, we measured it, I’ll print the image, trim it to size and cover up that little section. It will be pretty seamless. You would be hard-pressed to do that with other materials and have it look as good as it does with Print-N-Stick,” adds Wredberg.

Regan has been involved in the sign and wide format digital printing industries for the past two decades as an editor, writer and pundit. With a degree in journalism from the University of Houston, Regan has reported on the full evolution of the inkjet printing industry since the first digital printers began appearing on the scene.

Leave a comment

Please be polite. We appreciate that. Your email address will not be published and required fields are marked

*