Wall Wraps Before and After at the Boom Boom Room | LexJet Blog
BEGIN TYPING YOUR SEARCH ABOVE AND PRESS RETURN TO SEARCH. PRESS ESC TO CANCEL

Wall Wraps Before and After at the Boom Boom Room

Wall Graphics and Murals
The Boom Boom Room received a makeover courtesy of Heineken and DeCrescente Distributing with wall, elevator and door graphics printed on LexJet Simple Adhesive Vinyl.

Heineken wanted to make a big splash at a popular four-story tavern while making it easy to clean up all the splash-back from spilled drinks and such in the Boom Boom Room, a DJ-powered disco located on the fourth floor of the tavern.

Local beverage distributor DeCrescente Distributing, Mechanicville, N.Y., and its crack graphics design and installation staff took on the project, which required wraps on doors, elevators and walls of the Boom Boom Room.

Bar Makeover with Wall MuralsGraphic designer James Lane chose LexJet Simple WallCal (6 Mil) for most of the project, printing an entire roll to fill the space required, and scrim banner applied with LexJet Heavy Duty Banner Tape on one brick wall area. “That’s the other reason we went with those materials, because they spill drinks and throw stuff on the wall, so we wanted something that would take the abuse,” explains Lane.

“Heineken wanted that floor since they’re promoting their music series and did this as part of the sponsorship. The City Tavern wasn’t too keen on it at first since it had always been Budweiser, but when I was installing the project they changed their minds because they thought it looked great,” says Lane. “It took about 11 hours to apply it. This is not something you rush through; you have to take your time to get it right.”

Elevator GraphicsLane has been designing and installing graphics for years and has the process down to a science (his graphics department comrade Monty Pyle says Lane’s been doing this for “a reeeaaally long time”). While experience helps a lot, Lane says: “We all take pride in our work. We want to do a good job and we don’t stop until it’s done right. It’s better to take your time. I look at the room and get ideas so I know what I’m doing before I leave that room. It’s a matter of pre-planning the project ahead of time and taking exact measurements.”

The project was printed on DeCrescente’s Epson GS6000 low-solvent printer, and Lane says it took a couple of days to print and cut the graphics into the various panel sizes.

“Before I printed everything out I printed a section on the HP to see what the background would look like. It looked good on-screen, but when I printed it out it didn’t look so good, so I had to redo the background as far as tracing the lines and getting the colors right. We always make sure our images aren’t pixilated and are razor sharp before we go into production,” adds Lane.

Regan has been involved in the sign and wide format digital printing industries for the past two decades as an editor, writer and pundit. With a degree in journalism from the University of Houston, Regan has reported on the full evolution of the inkjet printing industry since the first digital printers began appearing on the scene.

Leave a comment

Please be polite. We appreciate that. Your email address will not be published and required fields are marked

*